streching against the curve with RestoreX

[zrx1200mn]

Straight Stretching with RestoreX (15 minutes) is easy. Clamp it in and stretch to the Optimized Treatment Zone.

what is the Optimized Treatment Zone for Stretching against the curve?
I've found that if the Main Unit is flush against the Base Ring then I can stretch it out to four clicks; however if I raise the Main Unit several notches up from the Base Ring, and then start stretching against the curve, I can only go out three clicks - and it's a difficult three clicks.

Does Anyone have experience with this as well? I reviewed Dr. Trost's video and he showed that the Main Unit was Flush against the Base Ring.
 

[Jamesblue]

After 15 minutes straight stretch.
Release spring
Retract to base
Apply full 120 deg bend
Slide away from base to feeling of stretch
Slowly and carefully release spring
Keep monitoring that white line is buried

[zrx1200mn]

After 15 minutes straight stretch.
Release spring
Retract to base
Apply full 120 deg bend
Slide away from base to feeling of stretch
Slowly and carefully release spring
Keep monitoring that white line is buried

This was copied from the website and anyone who has used RestoreX is familiar with the basic steps.
Does anyone have something to add that is not copied from the RestoreX website?

[Pfract]

zrx1200mn:

There are a lot of posts around on restorex but it may be very hard to comb through all of them. Have you tried emailing customer support on this one? i did it back in the day and they were not that bad at all.

[Jamesblue]

This was copied from the website and anyone who has used RestoreX is familiar with the basic steps.
Does anyone have something to add that is not copied from the RestoreX website?

Was not copied from website

[zrx1200mn]

zrx1200mn:

There are a lot of posts around on restorex but it may be very hard to comb through all of them. Have you tried emailing customer support on this one? i did it back in the day and they were not that bad at all.

I have not emailed restorex. I'll contact them and report back, as to what they recommend. Thanks.

[zrx1200mn]

email exchange with RestoreX

For clarification - here is what I wrote in my original message:

what is the Optimized Treatment Zone for Stretching against the curve?
I've found that if the Main Unit is flush against the Base Ring then I can stretch it out to four clicks; however if I raise the Main Unit several notches up from the Base Ring, and then start stretching against the curve, I can only go out three clicks - and it's a difficult three clicks.

Treatment Example 1: When I'm stretching against the curve and the Main Unit is FLUSH with the Base Ring, I can bend it over using all FOUR CLICKS. The MAIN UNIT will only slightly rise from the BASE RING. The white lines are not visible.


however; this where my question is detailed - in example two.


Treatment Example 2: When I move the MAIN UNIT up two or Three notches from the BASE RING and pull it over to stretch against the curve, that is where I can only bend it over to THREE clicks, and it is difficult to bend it over to the THREE click point.

Which one of these two examples is my best treatment option?

The following is from RestoreX:

If we understand you correctly, your first example is likely best because you can get to the fourth rotation position and the white lines are not visible. You do not need to continue adding notches to the extension rods (example 2) if the white line are already hidden.

PathRight Medical Support Team