Hey, everyone. I had a quick question that I wanted input on regarding the clamp position on my Restorex. The instructions indicate to put the clamp at position 2 if the curve starts 2 to 3 inches down, and to position 3 if it's more than 3 inches. Mine is probably just a tiny bit over 3 inches down, maybe 3 1/4 inches at most.
Do you guys think it would be better to set the clamp at position 2 or position 3 with this in mind? I can't seem to make up my mind on this matter and seem to change the clamp position every other day...
Hi there, good question concerning the clamp position and can I offer you a good answer?
If you are stretching for 15 minutes in straight then counterbending for a further 15 minutes at the FULL 120 degrees I say it's perfectly ok to change it everyday - that way you are positively making sure you maximize the benefits.
Good luck keep diligently adherence to the regime and don't be influenced by others that have less patience.
As it has been said over and over here by many who have done the hard yards and seen good results - "this is a marathon not a race"
.
.
Ditto what Jamesblue said.
Thank you both for the response. Think I will try this!
I have a similar question: the distance I got between the tip of the penis and the curvature was 2.7in, so position 2. But visually the clamp seemed to be clearly above the plaque region. Customer support told me I could try position 3 if the distance is more than 3in. What would you guys do?