I have purchased and attempted to use the SOMAerrect 3 cylinder VED and am having some difficulty getting a good seal. I am using lubrication but I feel that even if I press down slightly underneath the base of my penis where it meets the scrotum it causes that area some discomfort, not to mention there are some gaps there because of the folds of skin. Lastly, I feel as if some of my scrotum skin is getting sucked into the tub when pumping in that area. Are there any accessories that can assist with this or any ideas on if I am doing something wrong?
Most important is that the tube fits well (not too small obviously, but not so big it sucks your testicles in either) and you should shave before using. With pubes in the way you can't get a proper seal. Make sure the skin is smooth and use plenty of lube. Also, don't overpump cause if yoy're like me even a jerkoff session or very carefull ved use will result in more and more damage.
Hi, which cylinder are you using, have you fitted the correct rubber seal to the end.
Also, check out the penis sleeves
One trick I used to use was shaking my penis in the tube at a downward angle while standing. This sounds pretty odd but it worked for me to get a seal. Be careful!
Shaking is actually a good idea. It's used by the girth increase pumping folks to stimulate a semi. I do that, too, because I'm a grower and flaccid won't stop pulling in other skin and if using a smaller tube would be disastrous in case of full blown erection.
I managed to get a proper seal. Has anyone had any small red spider veins showing up on their penis after using VED? I don't if they have always been there or if it is the VED that caused them. Any thoughts? Should I discontinue use?
You may be using too much pressure. If they go away after an hour or so, I wouldn't worry. I sometimes get little subcutaneous blood blisters on the head. They go away fast. Always stay in the comfort zone. It should feel a little pulling to all sides, but not more. Just a gentle stretch.