Peyronies Society Forums

Peyronies Disease TREATMENT Discussion Boards => Traction and Traction Devices for correcting Peyronies Disease => Topic started by: markdubby on July 19, 2021, 04:38:00 PM

Title: stiffness when putting PMP on
Post by: markdubby on July 19, 2021, 04:38:00 PM
Hi all

sometimes when i put the PMP on for the first time before a session, i feel my penis is quite inelastic and it poses quite a lot of resistance and feels tight for 30 seconds/minute, then it eases in.

is this quite normal or am i damaging my penis? (i use very low tension these days, pretty much at the first line when there is no extension and 480 g at maximum extension with the rods).

thanks!
Title: Re: stiffness when putting PMP on
Post by: Mikel7 on July 20, 2021, 06:32:07 AM
I sometimes experience this also. It is kind of like a tug of war or the penis retracting and fighting back.  After
about 5 minutes things relax a bit more - gentle heat helps a lot in relaxing things.  You are not damaging things at all.
Title: Re: stiffness when putting PMP on
Post by: Juan on July 20, 2021, 08:19:55 AM
that also happens to me when I put the pmp on. What I do is to start the traction session layed down as for some reason my penis is more flexible than stand up.

I'd like to ask you guys if do you also have that sensation of like a hard flaccid when you take the pmp off.
Title: Re: stiffness when putting PMP on
Post by: markdubby on July 20, 2021, 08:35:04 AM
yeah it's a bit painful for a while. especially after repeated 2 or 3 x 2 hour sessions. i usually stop for the day when that feeling gets too intense
Title: Re: stiffness when putting PMP on
Post by: JamieKer56 on July 20, 2021, 01:36:22 PM

That also happens to me.

Sometimes it seems I've reached the point of pulling things too much when moving the glans chamber over the clip at the end of the PMP, but thankfully it gets there without any catastrophe's

JK