I've been using the RestoreX for two weeks now.
I take 400mg of Pentox three times a day.
I will do two sessions a day for 30mins.
I begin with my boy in the straight out position and release the springs on the tension rods.
After 10 mins I adjust the device downward in a slight bend and gradually increase the bend angle downward as I get closer to the 30mins.
My biggest challenge on certain days is getting my head clamped in the front of the device. Somedays I really have to grab and pull him up and other days I can just lay his head in there and clamp him down without a problem.
Do you take and Viagra or Cialis before the days first routine? Do you warm him up with a rice bag to relax him?
Do you have any recommendations as to what I could be doing better in my routine?
Are there any lubricants you can use after the sessions? Is that helpful?
I'm real curious what type of routine or preparation you go thorough to help your fella down there?
22 views and not one single F^@$!ng message?!
After your initial 15 mins straight stretch
Release tension , apply full angle of bend
Then apply tension mi my
15 minutes straight on the long rods followed by 15 minutes full bend on the short rods.
Morning and night.
Quote from: memnoch on March 09, 2022, 05:40:39 AM
15 minutes straight on the long rods followed by 15 minutes full bend on the short rods.
Morning and night.
same here but I take a 30 minute rest between the 30 minute sessions.
Many thanks to all of you for your feedback and I will follow your advice!
So you guys aren't unclamping then re-clamping after the straight traction? Is it okay to just keep the head clamped as you switch to counter end ? No need to release n rest for few mins?
I stay clamped but then again I can rarely reach counter bend 2.
i have a curve to the right, so I have to release the clamp and turn restoreX and reclamp it to pull to the left.
Quote from: jj21 on April 11, 2022, 07:05:34 AM
So you guys aren't unclamping then re-clamping after the straight traction? Is it okay to just keep the head clamped as you switch to counter end ? No need to release n rest for few mins?
Since I have to change the base for the shorter rods for counter bend, I must unclamp. But no rest or pause. I unclamp, remove the device, switch bases, reclamp, counter bend, extend, then release.
Quote from: memnoch on April 14, 2022, 05:33:18 AM
Since I have to change the base for the shorter rods for counter bend, I must unclamp. But no rest or pause. I unclamp, remove the device, switch bases, reclamp, counter bend, extend, then release.
Did you buy another base? I'm at the white lines when stretching because I have the clamp at the lowest position,
Yes. It was $25 iirc. Pretty quick and easy to order, just contact them. I think it is a design flaw, both rod lengths should work straight and full counter bend for all clicks on them imho. Or they should include the two bases with the rods permanently attached with purchase.