This post is for Old Man, Tim 246 and other
VED experts. I've bought a SomaErect 3-cylinder
VED (after advice from Old Man) and I just want to try to pull out the one dent I have developed in the LH side - I'm still straight, no
Erectile Dysfunction, no pain, no length or
girth loss except specifically at the dent, no palpable plaques (I know you can't always feel plaques) and developed the dent quite suddenly in November 2012.
I've downloaded the protocol and I noticed the instruction about not using the 'A' cylinder if the penis is on the large side, so I decided to start with the modified protocol, substituting B for A on the protocol.
I shall be resting off the
VED for a while (see my other post on
VED and Penile Lymphocele), but when I do restart I was after some advice:
- As I don't need straightening or regain any lost length, but just want to try to improve a single dent, should I be using the 3-cyl protocol or is there a single-cylinder protocol that may be more effective, like the one from jackp & Old Man in the stickies? The tightness of the B cylinder means I am not getting any stretch in girth on the dent when pumped
- Should I be trying to use the A cylinder, even though I will not be able to get anywhere near a full erection in that tube?
- Any other advice for dent repair?
For the first day or so of the protocol I did feel a slight "pull" in the area of the dent, which was encouraging, but now feel nothing specific in that area, even when fully pumped. I have been getting a pretty good vacuum from the Soma, but may have been over-doing it, despite no pain, discomfort, oedema or red marks during or after pumping, just a little minor discomfort where the rubber base of the cylinder "digs in" to my pubis as it pulls back under the effect of the vacuum. I think I'll go easier and try to hold the cylinder to stop it digging in when I restart.
All help and advice gratefully received.