3 Cylinder Protocol, 1 week down - a few questions

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Dylan

1 week down, 25 to go! :)

So far, so good. No pain or discomfort. I've tried to stick as close as possible to the protocol. I pump up slowly, as far as I can without any discomfort (takes about 20 seconds), then hold it for 10-15 seconds, and rest for 10 seconds. I must say I have a little trouble with the size of the A cylinder, getting in there initially is like squeezing a fat girl into skinny jeans.  ;D When I start expanding, the head is pressing tight enough against the cylinder, to start turning a bit blue around the bottom of the head. It's just from pressing against the cylinder, like when you press your finger against glass, and it turns white. It doesn't hurt, but it's really tight in there and I can't come close to full expansion length or girth wise. Sometimes, even after I release the vacuum, the erection barely goes down because it's tight. Old man has been helpful in his PM's and said not to worry about full erection. Just wondering how other people feel about the tightness of the cylinder, and whether or not they skip this one? Even in the B cylinder it's pretty tight, So if I did skip A, it wouldn't negate the benefit of keeping the erection in a close tight seal.

james1947

Dylan

From what you are writing you don't have enough lubricant in the cylinder or the cylinder A is too small for your penis.
You should try more lubricant and if it is the same, replace it with the B cylinder. You have mentioned also that even cylinder B is tight so maybe A is really to small.
Old man is right not to worry about full erection in this stage, but I don't think is good that the head turning blue.

James
Age 71, Peyronies from Jan 2009 following penis fracture during sex. Severe ED.
Lost 2" length and a lot of girth. Late start, still VED, Cialis & Pentox helped. Prostate surgery 2014.
Got amazing support on the forum