RestoreX More Than Just Hiding White Lines?

[hopn4thebest]

Hi,

Ive been using restoreX for a while. I was wondering if the correct tension is when the white lines are only just covered, or can you have it even closer to the lock position. Ive been adjusting the tension so that there's only 1cm or so of the black rods showing at any given time and I'm just realizing perhaps this is too much.

This is for when it's straight. When it's bent the white lines are well and truly covered and that's at the lowest length.

Thanks

[GaussRifle]

When fully stretched , even I have just about 1 cm of black rod showing so we are applying the same amount of tension which is quite a bit but normal I think.

[MauleFlyer]

I spoke w/ Restorex customer service and asked about the amount of tension at various points of the rods being exposed.  I forget the exact numbers but with just a little of the rods showing the tension is a bit over twice what it is with the white line just covered.

The reason I asked was I was having new pain in my left testicle on my first series of uses of the Restorex and had been using quite small amounts of the black rods showing since as time went along during a session  the white rings would appear.

My urologist suggested I give the Restorex a rest and try again. I am on my second start now and after a 1 month layoff am only just covering the white rings.  Hopefully this will work without the pain.