How to properly measure angle and length

[Rocodile]

Hi all,
How do I measure angle of my bend? I've never quite understood it.
Thanks

[Hawk]

There are a few ways to measure a curve. One way is to take a photo from an angle that shows the curve. Then on the photo, draw a straight line beginning at the base continue along in a straight line as The pixies would go if there were no bend. Draw another line beginning at the tip and continue in a straight line back.  At some point, these lines will intersect. Here is an example. https://www.peyroniesforum.net/index.php?action=dlattach;topic=10898.0;attach=2047;image

This photo shows a minor curve, actually more of a tilt, so it is not the best example but should give you a good idea.  Then get a protractor to measure the angle.

Here are further instructions https://www.peyroniesforum.net/index.php/topic,4760.0.html (in this example I think the bend is a little less because I think the one line is slightly off.

Here is another method. https://sharpscalpel.com/curvature/


PS: You must have a full erection because the degree of erection will affect the degree of curve.

[Rocodile]

Perfect!  thank you.  

[Hawk]

Rocidile,

I corrected my post and added another source.

Hawk