Peyronies Society Forums

Peyronies Disease TREATMENT Discussion Boards => Traction and Traction Devices for correcting Peyronies Disease => Topic started by: RedWilly on November 14, 2017, 03:07:55 PM

Title: Stop traction when pain starts again?
Post by: RedWilly on November 14, 2017, 03:07:55 PM
Should traction be stopped if there pain? Been using as directed, but getting really sore and erectjon quality is next to nothing.

If so, how long should it be stopped for?
Title: Re: Stop traction when pain starts again?
Post by: LWillisjr on November 18, 2017, 09:43:56 AM
Is the pain while you are wearing the device, of all the time?
Title: Re: Stop traction when pain starts again?
Post by: swiss on November 18, 2017, 01:19:23 PM
I would stop a bit and restart once the pain goes away. I think if you go hard flaccid after traction thats not good. When that happens I take a few days rest, apply heat and lower the traction tension when I restart (hard flaccid only happened once at the start of traction therapy and went away in a day or two)

I have had lower erection quality after a traction session and some pain...but no new plaque. That's probably the worst you can expect. GO SLOW.
Title: Re: Stop traction when pain starts again?
Post by: RedWilly on November 28, 2017, 03:58:33 AM
It's pain after i use the traction for a period of time followed by pain after. Mostly dull aches in the area of the scar tissue. Then i get low erection quality...

Is this normal for this type of treatment?